A short session this morning to finish off the boot carpeting.
There is a single, large piece to go on the inside of the rear panel. I could see that being a nightmare to fit myself so I cut it into 3 pieces - much easier:
I haven't glued in the base piece because I first want to buy a sheet of foam to go above the fuel tank to protect it and raise that section to the same level as the bonded in side pieces. I will not glue it in the section above the diff access plate for obvious reasons and I'm not even sure if I should bother sticking it anywhere else - I'll see.
Unleashed the seatbelts - looking good:
Next up are the seats - going to be tricky as my seats are a bit large...
No comments:
Post a Comment